Down to Earth strives to provide excellence in training and assessing
Phone 08 9528 8888
RTO 51199

MEM05019D Weld using Gas Tungsten Arc Welding Process

MEM05019D Weld using Gas Tungsten Arc Welding Process

Our 5-day Intermediate Gas Tungsten Arc (TIG) Welding course covers the preparation, positioning, fixing, and manual welding techniques associated with general trade level welding using gas tungsten arc welding equipment. It includes the selection and set up of the equipment appropriate to both the material and the weld to be performed, carrying out the GTAW to prescribed standards, and examining for and correcting defects, in a range of welded fabrications.

General Information

  • ✔ Cost $1600 per person
  • ✔ Duration 5 days
  • ✔ Face to face training
  • ✔ Nationally recognised
  • ✔ Real practical training!

Course Content

  • Site requirements and information.
  • Preparing materials for welding.
  • Hazards in welding and preventative measures.
  • Welding equipment and consumables.
  • Welding symbols.
  • Weld positions.
  • Operating principles and process variables.
  • Minimise and rectify weld distortion.
  • Heating and cooling.
  • Cutting.
  • Testing techniques.
  • Faults.
  • Weld procedures.


All candidates that successfully complete the course will be issued with a statement of attainment for MEM05019D Weld using Gas Tungsten Arc Welding Process (as shown below). This is a nationally recognised unit of competency.

Manual Metal Arc Welding (Basic) MEM05012C certificate

Candidate Requirements

  • Must have good verbal and written comprehension of the English language;
  • Must wear long sleeved shirt, long leg pants and steel cap boots. PPE will be provided but you are welcome to bring your own if preferred;
  • Must hold a USI (unique student identifier) number. Click here for further information:
  • Pre-requisite units (must bring evidence of completion of these units):
    • - MEM05049B Perform Routine Gas Tungsten Arc Welding;
    • - MEM05051A Select welding processes (DTE pre-course booklet);
    • - MEM05052A Apply safe welding practices (DTE pre-course booklet);
    • - MEM12023A Perform engineering measurements (DTE pre-course booklet);
    • - MEM18001C Use hand tools (DTE pre-course booklet);
    • - MEM18002B Use power tools/hand held operations (DTE pre-course booklet).

Language, Literacy and Numeracy

Adjustments to training can be made for participants with language, literacy and numeracy issues so that they are not disadvantaged in completing this course. Please inform our office at the time of booking your course if you experience any language, literacy or numeracy issues.

Training Location

This course is offered in-house at our premises in Rockingham, Western Australia. The course can also be delivered on-site at your location if preferred. Please enquire if you would like a quote or further information regarding on-site training – Phone (08) 9528 8888.

Course Cost

The cost to attend an in-house scheduled course at our premises is $1600 per person. The CTF subsidy rate is available to eligible candidates.

The pre-course assessment booklet and resource manual can be provided to you by DTE at a cost of $100 (see candidate requirements).

BCITF Construction Training FundThe Construction Training Fund provides funding support for training of eligible workers in the construction industry. We acknowledge the support of the Construction Training Fund in reducing the costs of training for eligible workers.


Please request a quote if you would like to arrange this course to be delivered on-site training at your premises – Phone (08) 9528 8888.